Guz,

I don't think that time between application and removal is the issue. If this followed the normal issues with Gliss that CarPro describes, then it would not buff off and I would have to reapply to get it to loosen up. As I said above, I tried just about everything for dwell time from 1 minute to 15 minutes. It takes close to a minute to apply the coating on a partial panel. It was probably about 60F in the garage when I applied it, so not terribly warm but not cold either. I watched it closely a couple times to see when it had flashed and then buffed. Again, no matter what I did in the process or with different towels, I still got the white fuzz which I believe was the Gliss just coming off.

Thanks again for giving your thoughts.