Accidentally got clay under vinyl stripes. How to remove?

[JFunnyman]

So I coated my car yesterday evening and because I didn’t have a whole lot of light when I was finishing up I got a bit of clay underneath the side of one of the stripes.. I tried to remove it by gently running my fingernail down the stripe but couldn’t get much out. How do I go about removing the rest of the clay? Any tips?

[DBAILEY]

toothpick?

[JFunnyman]

toothpick?

That was my first thought. Didn’t know if anyone else had a better solution, toothpick will definitely work though.

[osiapstndp]

Which clay did you use?

I used the Mother's yellow clay a few years ago and it would always leave behind little bits of itself on the edge of vinyl stripes. What worked really well for me was to use the Pinnacle green clay on the affected edge - it will pull up the tiny bits of remaining clay and at the same time, if used gently, will not shear off on the vinyl.

If you want to try this just use a tiny bit of the Pinnacle clay (or any other very soft clay). Think the size of your pinky fingernail. Then, with a good amount of lubricant, gently rub over the area repeatedly until the errant bits are removed.

[JFunnyman]

Which clay did you use?

I used the Mother's yellow clay a few years ago and it would always leave behind little bits of itself on the edge of vinyl stripes. What worked really well for me was to use the Pinnacle green clay on the affected edge - it will pull up the tiny bits of remaining clay and at the same time, if used gently, will not shear off on the vinyl.

If you want to try this just use a tiny bit of the Pinnacle clay (or any other very soft clay). Think the size of your pinky fingernail. Then, with a good amount of lubricant, gently rub over the area repeatedly until the errant bits are removed.

I used the Megs clay that comes with their clay kit, I’m sure that’s at least a medium clay.

[hooked]

Soft bristled toothbrush or detailing brush with gentle scrubbing?

[JKDesign]

Toothpick and a detail spray/clay lube should do the trick

[Sleper]

Toothpick and a detail spray/clay lube should do the trick

I agree with lots of lube so you do not marr

[Desertnate]

Is the clay under the stripe like the title of your thread, or simply built up along the edge of the stripes? If it is actually under, I'd be afraid this would start to loosen the stripes and digging it out with a toothpick, even if you're very gentle, would cause them to loosen even more and could bubble or peel in the future. If it's simply built up along the edges, I'd agree with the toothpick approach.

[JFunnyman]

Is the clay under the stripe like the title of your thread, or simply built up along the edge of the stripes? If it is actually under, I'd be afraid this would start to loosen the stripes and digging it out with a toothpick, even if you're very gentle, would cause them to loosen even more and could bubble or peel in the future. If it's simply built up along the edges, I'd agree with the toothpick approach.

Built up on the edges would be a better description than under. The stripes haven’t lifted up on the sides or anything like that. Sounds like toothpick and detail spray is the way to go.