Foam Cannon Recommendation for Sun Joe SPX3000

[HAMBO]

Hi everyone,

Trying to pick a foam cannon for this, leaning towards MTM Hydro Parts. There are a few options on AG; PF22, featherweight and regular I believe. Any guidance as to which one to pick for a Sun Joe SPX3000?

Thanks!

HAMBO

[ShinyGC]

The PF22 does not have the correct orifice for low pressure units. However you can buy the 1.1mm orifice separately.

I have the SPX300 as well and use the one i linked below... just make sure to swap out the pre installed orifice nozzle for the 1.1mm (included in the kit).

MTM Hydro Original Foam Cannon Kit - 14.5012 - MTM Hydro Parts

[HAMBO]

The PF22 does not have the correct orifice for low pressure units. However you can buy the 1.1mm orifice separately.

I have the SPX300 as well and use the one i linked below... just make sure to swap out the pre installed orifice nozzle for the 1.1mm (included in the kit).

MTM Hydro Original Foam Cannon Kit - 14.5012 - MTM Hydro Parts

Thanks! I was wondering whether that’s indeed still the case? The link below suggests the PF22 now comes with the 1.1mm alteady;
MTM Hydro PF22 Foam Cannon - 14.5013 - MTM Hydro Parts