Meguiars Mirror Glaze 4

**primo spaghetti** · 12-24-2012, 02:38 PM

So im looking to get some deeper scratches out this week and remembered i had heavy cut cleaner.

Curiously i was reading the label and it says for rotary tool only. i lent my rotary out (can probably get it back tomorrow), but i was wondering if i could use it on my flex. im not looking to experiment because i plan on using it on black.

anyone try it on a DA?

**mwoolfso** · 12-25-2012, 07:24 AM

Here is a review on the product on AG's store.... I think one can begin to understand why a DA is not a primary recommendation for the product. You may be able to make it work if you had no other choice.

"Definitely works to remove clearcoat scratches. I used a Porter Cable set to 5 and an orange Lake Country foam CCS pad. Took out the scratches without paint damage. Followed up with XMT #3, then XMT #1. Reason for 3 stars: 1. Very difficult to clean out of your foam pad. Greasy residue is immune to dish liquid or XMT pad cleaner. Had to basically squeeze the gummy residue out and then clean and reclean my pads. A lot of time taken to get a rfresh clean pad 2. Too runny and does not stay on the pad surface. Slings off and soaks in."

**primo spaghetti** · 12-25-2012, 08:54 AM

great thanks for finding that review...

ive used it in the past on my rotary and found it actually worked alright...so of course im sure thats maybe why it says for rotary use only.

i got the rotary back this morning, so im sure ill get by with the other stuff i have on the rotary...but i will probably try it again!!! haha