Griot's G21 with 5" BP

[Dan Tran]

PLEASE PLEASE PLEASE... Forgive me because I know this question has eventually been tossed out there.

Did I make a good choice for a machine combo???

I used a g21 with the 6" before but I thought this combo was more smoother in terms of vibration etc. anyone with the 6" g21 combo disagree?

I bought a load of 5" pads from griot to match the machine.

Did I make s mistake and should have gone with the G15??

I know curves and tight areas benefit with smaller throw and 3" but aside from that... is the G15 more better overall vs G21 with 5" BP??

[WRAPT C5Z06]

NO, be glad you got the G21. The 5" BP makes it that much better.

[Dan Tran]

Speaking of curves... And again probably premature to speak of this but anybody think the new rupes mark Il will be better than what griots already has in place.

I know griots offers the inner flex pad to help with curves etc.

I can't wait for an a/b comparison though i don't doubt the rupes will not disappoint

[VISITOR]

you made a good choice with the BOSS, enjoy it! :)

[Justin at Final Inspection]

Ever since I bought my g21 I have only used it with there 5.5in BOSS pads. No disappointments here.

[Billy Baldone]

I use the 5.5" pads most of the time. I only use 6" on long panels. You made the right choice

[Joe@NextLevelDetail]

I have the entire boss system.

And at first I used the 5 inch with the g21, I however enjoy my 6.5 inch pads much more.

Its smoother for me. And a better experience. Comfort wise.

Not that its not smooth with the 5 inch IMO its just smoother with the 6 its more balanced.

However. If you swap the 5 inch plate. And its still comfortable for you. Don't be so down that you didn't get the 15.

The only reason you would want a 15 for tighter areas in example above doorhandle the 21 might be too much . but even in that case I still use a smaller machine in those areas.

Its not that much of a diffrence however a 6mm diffrence in throw is a lot considering the pc7424 is just a 8mm throw lol.