PNS vs. WG Trim Sealant

[tenblade2001]

I going to be doing the winter prep soon (still sunny here in The South) and am considering two different options:
(1) WG trim sealant- I had a sample and really liked it, shine and durability were good
Vs.
(2) TW Endurashine with PNS over it. I've never used PNS, but several threads I've read and videos state that it can be used on trim.
Thoughts?

[DBAILEY]

Sounds pretty interesting. I don't recall PNS being heavy on the solvents so it may apply fine over the TW.

I do a similar thing with Carpro PERL, hard buff after 15-20 minutes, then mist a MF with Reload and wipe the trim down. Greatly increases the durability without removing the restorative effect that PERL accomplished.

[tenblade2001]

thanks...maybe I'll try a test area and report back.

[Evan.J]

The PNS will give you nice protection and a little bit of shine but not too much shine. If the trim is faded I would sure a more trim specific product. If the vehicle is new then go ahead and use PNS.

[tenblade2001]

@evan, I was going to use TW endurashine to give deep, but not glossy black, and then PNS to add protection.

[Evan.J]

@evan, I was going to use TW endurashine to give deep, but not glossy black, and then PNS to add protection.

You can try that but I'm not sure how long the PNS will last

[Rsurfer]

@evan, I was going to use TW endurashine to give deep, but not glossy black, and then PNS to add protection.

You would be better off using Car Pro's Dlux.

[Mantilgh]

You can try topping it, but the TurtleWax product has pretty good durability by itself. 6 months so far on some test spots on my car.