pbps4
04-21-2015, 05:12 PM
Hello all,
I have a couple of questions. They are quite specific.
1. I just finished the claybar process and now I am about to apply the Wolfgang Paintwork Polish Enhancer by hand. What is the best applicator to use? Is it okay to use a red (wax) foam pad? Or is it better to use a more aggressive foam pad (yellow/white)? The bottle says to use terry or microfiber but I prefer not to use microfiber unless its for drying or buffing. Some tips on technique would be appreciated as well (how long before removal, etc).
2. I also have Suntek 3m paint protection film on the front end and I have used the claybar on it as well. Is it necessary or even safe to use WGPPE on it? Should I just skip putting it on there and go straight to the sealant after I finish the rest of the car?
3. After the winter, some water spotting has occurred on the rubber trims around the pillars and doors. I cannot remove them with easily and I need advice on what to use to get the rubber looking nice and clean before I use 303 aerospace on them to get them very black.
Thank you guys for helping a detailer in need!!!! :cruisin:
I have a couple of questions. They are quite specific.
1. I just finished the claybar process and now I am about to apply the Wolfgang Paintwork Polish Enhancer by hand. What is the best applicator to use? Is it okay to use a red (wax) foam pad? Or is it better to use a more aggressive foam pad (yellow/white)? The bottle says to use terry or microfiber but I prefer not to use microfiber unless its for drying or buffing. Some tips on technique would be appreciated as well (how long before removal, etc).
2. I also have Suntek 3m paint protection film on the front end and I have used the claybar on it as well. Is it necessary or even safe to use WGPPE on it? Should I just skip putting it on there and go straight to the sealant after I finish the rest of the car?
3. After the winter, some water spotting has occurred on the rubber trims around the pillars and doors. I cannot remove them with easily and I need advice on what to use to get the rubber looking nice and clean before I use 303 aerospace on them to get them very black.
Thank you guys for helping a detailer in need!!!! :cruisin: