View Full Version : How to shorten pressure washer gun???
BMGz33
10-13-2014, 11:22 AM
I'm trying to delete the wand off the gun and just be able to connect a quick disconnect fitting to the tip of the gun to shorten it but I can't find the right fitting, any help is appreciated...
I have a craftsman pressure washer, I tried looking on amazon for the right fitting but I'm completely lost :confused:
Any help is appreciated, thank you :xyxthumbs:
Don M
10-13-2014, 02:22 PM
Could you cut the barrel down to the desired length and rethread the end?
cardaddy
10-13-2014, 02:32 PM
Should be able to find all the various fittings you need at Northern Tool. If nothing else.... you can get a new gun/wand and build it however you want. :)
drbll
10-13-2014, 02:50 PM
Lavor Pressure Washer Fitting (http://www.autogeek.net/lavor-fitting.html) I used one of these, plus a short nipple, to put my foam gun right onto the Craftsman wand, it is the Lavor type fitting.
spiralout462
10-13-2014, 10:11 PM
Pressure Washers Industrial & Commercial (http://www.watercannon.com). They have it all!
I have had success at my local hardware store. They have had pretty much anything I needed for pressure washers.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.