How to do you apply tire dressing with paintbrush?

[stemyx]

Hi guys, today I tried the paintbrush technique with Opti-Bond and a 1 1/2 inch brush and it did not go as well as I expected. How do you guys apply it? Do I need a bigger brush? A better dressing? The dressing started streaking and it seemed like I was not putting enough it didn't spread as well. Any suggestions?

Sent from my Nexus 4 using AG Online

[dsg03gt]

I use a 3" paint brush and then use a MF towel to even it out. Never had any streaking issues.

[stemyx]

I use a 3" paint brush and then use a MF towel to even it out. Never had any streaking issues.

What tire dressing do you use? And do you put dressing on the bristles?

Sent from my Nexus 4 using AG Online

[dsg03gt]

Opti-Bond. I put the dressing into a container and just dip the brush into it. I sometimes mix it with water to get my desired shine.

[Vtextc]

I received a bottle of SwissVax Pneu dressing with a brush as a gift last year. Save it for my garage queen only because it is so expensive (but not the greatest dressing IMO). Typically, I hold the brush against a MF cloth (to prevent overspray), and spray the dressing straight onto the bristles before applying.

Asif

[CDot]

Not a paintbrush, but I use these Carrand Brush & Shine Tire Dressing Applicators, tire brush, tire shine applicator (http://www.autogeek.net/carrand-tire-dressing-brush.html) and they are awesome. I don't need to even anything out with a MF; just keep brushing along the tire to get an even finish.

Oh, and my current tire dressing is Eco Touch Tire Shine (http://www.autogeek.net/eco-touch-tire-shine.html).

[PA DETAILER]

The carrand tire brush is the way to go!

[Pockets@PoorboysWorld]

I used just your standard low quality 3" eco brush from Home Depot to dress the 35's on my truck with Bold n Bright (Liquid Version)

I start by going around the outside of the tire then finish by getting nice and close to the rim so I can suck up and redistribute any drips that might get onto the rim.

[stemyx]

Anyone ever tried cutting the bristles short on a cheap brush for stiffer bristles?

Sent from my Nexus 4 using AG Online

[DaHen]

Anyone ever tried cutting the bristles short on a cheap brush for stiffer bristles?


Yes. I find it easier to force the product into the lettering on the tire. :xyxthumbs:

[Rush Industries]

Actually, I suggest not using a paintbrush at all. Years ago, I thought the paintbrush was a great way to apply dressing... and it was definitely an improvement on previous methods that I was familiar with. However, for the last few years I have been using foam. Specifically, I purchase a sheet of 2 inch thick soft upholstery foam from the fabric store and then cut pieces off to size. Approx 2'x3', or whatever size feels comfortable to you. The foam soaks, holds and then distributes your dressing great. Another reason I prefer this foam method is precision. The edges make it very easy to control where the dressing is applied and makes a great edge that fits in between the tire and the wheel rim. When that piece is worn out, you simply cut off a new piece of foam using scissors and you are good to go.