View Full Version : Backing plate cutting into foam pad
PERFECTIONPLUS
03-25-2014, 04:51 PM
Im using a 6.5" foam soft buff meguiars cutting pad with a meguiars 7" backing plate on a gg6 and the plate cuts into the backside of the foam pad .Any suggestions?
FUNX650
03-25-2014, 05:06 PM
Im using a 6.5" foam soft buff meguiars cutting pad with a meguiars 7" backing plate on a gg6 and the plate cuts into the backside of the foam pad .Any suggestions?
I'll suggest to use Meguiar's 5" B.P.
Bob
swanicyouth
03-25-2014, 05:31 PM
The plate that comes with the GG6 is 6" and should work fine with a 6.5" pad. You need a little wiggle room at the end of the pad. The BP shouldn't hang over the Velcro. If so, it can cut into the soft foam.
Pureshine
03-25-2014, 06:44 PM
I'll suggest to use Meguiar's 5" B.P.
Bob
:iagree:
CM8 6MT
03-25-2014, 06:55 PM
I'll suggest to use Meguiar's 5" B.P.
Bob
Indeed, the W67DA BP go with the 6.5's. Can also be used with the 5" MF Discs.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.