View Full Version : Terminology: Orbital throw
tm_ag
07-10-2007, 09:47 AM
I've read that orbital throw is the measurement of the side-to-side movement of the buffing pad. How will this effect your polishing results? For example, the Festool Rotex 125 has a sanding stroke of 3,7mm vs the Rotex 150's stroke 5mm.
Bence
07-10-2007, 07:05 PM
The pad throw is the diameter of the orbit circle.
Thejoyofdriving
07-10-2007, 07:11 PM
I think that the smaller the orbit the finer the finish, but i am not sure, anyone?
davet
07-10-2007, 09:41 PM
I have always being told that 5mm is the ideal orbit for detailing.
Thejoyofdriving
07-10-2007, 09:42 PM
i guess i made a good choice with the festool than.
Bence
07-11-2007, 04:18 PM
I think that the smaller the orbit the finer the finish, but i am not sure, anyone?
Yep, smaller orbit usually mean higher speeds which are beneficial to polish breakdown, heat generation and overall finishing ability.
davet, yes, 5 mm is a healthy compromise between effectivity vs. finish.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.