How do I remove surface contaminants after

[timn99]

the car has already been detailed with wax cleaner and sealant (I used Jeff Werkstatt's Prime Strong and 2 layers of Acrylic Jett Trigger)?

I notice a few small areas that seemed to be "raised" above the paint surface, not sure if its sap or something, but want to try to remove it.

Should I hit that spot with some clay, or tar/bug remover?

Thanks in advance.

[bambo2888]

Clay bar is usually for contaminants pitting into the paint, rather than sitting on the surface. But then again, it all depends on what exactly it is. A clay bar session couldnt hurt, but maybe consider a cleansing lotion to really CLEAN the paint, but it will remove the wax and sealant. If its a big deal, I would go ahead and strip everything off, get it to where you want, and start from scratch.

[OCDetails]

Yup. Clay is definitely the next step. That should be the next step after washing, actually. It is surprising what clay can remove that polishes and compounds can't. Here is a helpful little clip that I took this weekend if you needed any extra direction.

http://i2.photobucket.com/albums/y42/OCDetails/video/th_clay-new.jpg (http://s2.photobucket.com/albums/y42/OCDetails/video/?action=view&current=clay-new.flv)