PBL Coating safe to use on Krylon UV Spray clear?

[Ebf2k]

I have a couple of projects that I use Krylon UV clear on, then wet-sand/polish.
Is it safe to use my PBL Coating on top for some added protection?

http://sherwin.scene7.com/is/image/sw/paint_template-1?layer=comp&wid=250&fmt=jpeg&qlt=100,0&op_sharpen=0&resMode=sharp2&op_usm=0.0,0.0,0,0&iccEmbed=0&printRes=150&_tparam_layer_1_src=sw/uvresitclear

Here's the MSDS if that helps http://www.paintdocs.com/webmsds/webPDF.jsp?SITEID=DBS&UPC=724504013051

[Ebf2k]

I did a test on a smaller piece that I did last month so the paint should have been fully cured by now. The PBL Surface Cleansing Polish stripped it right off, LOL. I'll have to respray!

[The Guz]

Hmm that's no good. I wonder if the duplicolor clear from the perfect paint match would work better with PBL.

I just painted a set of center caps that I then wet sanded and followed up with M105/M205. The clear was still intact. Not sure if it's worth anything but that's my experience.

[Ebf2k]

Hmm that's no good. I wonder if the duplicolor clear from the perfect paint match would work better with PBL.

I just painted a set of center caps that I then wet sanded and followed up with M105/M205. The clear was still intact. Not sure if it's worth anything but that's my experience.

Does the Duplicolor have the UV protection like the Krylon? That's critical for the epoxy resin I'm using on these projects.

[The Guz]

I believe it does. I will have to check the can to double check.