View Full Version : Pinnacle GlassWork Water Spot Remover
RobertJ34
02-06-2014, 01:43 PM
Hello everyone--Does anyone know if Pinnacle GlassWork Water Spot Remover is safe for side mirrors?
Thanks!
Nick McKees37
02-06-2014, 01:57 PM
It sure is. :dblthumb2:
Just as you would with paint...use the least aggressive approach first. Start with a soft foam applicator, and go up front there (microfiber, terrycloth, etc).
RobertJ34
02-06-2014, 02:11 PM
Thanks, Nick!
van185
02-06-2014, 04:15 PM
I've used it on side mirrors numerous times. It works realy well. You will not believe the difference. Great product.
RobertJ34
02-06-2014, 04:56 PM
Good to hear, thanks!
I use this product a lot, and like it very much.
Also, just used it on side mirror ~1 hour ago. It can be applied by machine or by hand.
I apply by machine on general glass, and with a MF towel on side mirror.
Apply the product to a MF towel 'wrapped' over 1 or 2 fingers. Spread product and work with little to moderate pressure in fast and small circular movements, then move it freely working up-down, left-right. Work it on the corners of mirror like contouring it.
Work the product until it turns almost or entirely transparent. You'll feel when it's done.
Get a clean MF towel and wipe of residue (wipe off may be very easy).
Hope I've helped,
Kind Regards.
RobertJ34
02-06-2014, 05:49 PM
Much appreciated, Tato. Thanks for the advice.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.