Tornador air foam gun

[1carguy]

I am considering a Tornador foaming gun. Have several questions.

The gun would be used for washing my motorhome. I have an air supply on the motorhome that puts out up to 125psi. I also have an on board electric pressure washer with spot free DI tanks.

Questions:

1. Would this work with the psi that I have?
2. With the air hose attached I am concerned about the bottle sitting flat on the ground when I am brushing or rinsing. If it will not site flat, but falls to the side I am concerned about product coming out while laying on it's side. Thoughts?
3. Is this an efficient use of chemical without diluting with water? Would a foamer attached to my pressure washer be more efficient?
4. Any other thoughts about this item and my application?

Thanks

[HateSwirls]

Make sure your cfm is enough.
It should give you all the specs when reading the description of the foam gun.
Cfm is most important, if not enough your compressor will run and run.
Your psi sounds right though.

I have a 150psi compressor but the cfm is only 3.4 and the gun requires over 5 cfm.