BlackCoupe
06-04-2006, 02:17 PM
I've been reading on the Meguiars forum that they never recomend using cutting pads with the PC dap due to marring or hazing. Is the Lake country orange (light cutting) pad safe to use? I know to start less aggressive and move up but just wondering if anyone got new problems they couldn't get rid of using the orange one?
FWIW, the Orange Lake Country pad with Megs 83 does it for me when the Meg's yellow pad (8006) with 83 doesn't. I do follow with 80 with Megs 9006 pad. I had better luck j-eweling with the new white edge pad and XMT Ultra fine. I aordered some Menzerna's to try that. HOWEVER, I have only been at this a few months, and techinque is developing, so you really should be mindful of the "FWIW" part of my post. This all seems to be very technique dependent, so variations in pressure, arm speed spin rate, paint hardness, temperature, humidity and probably 10 other things seem to lead to different results.
FWIW, the Orange Lake Country pad with Megs 83 does it for me when the Meg's yellow pad (8006) with 83 doesn't. I do follow with 80 with Megs 9006 pad. I had better luck j-eweling with the new white edge pad and XMT Ultra fine. I aordered some Menzerna's to try that. HOWEVER, I have only been at this a few months, and techinque is developing, so you really should be mindful of the "FWIW" part of my post. This all seems to be very technique dependent, so variations in pressure, arm speed spin rate, paint hardness, temperature, humidity and probably 10 other things seem to lead to different results.