Getechniq

[fast01gt]

Having the car detailed in two weeks then C1 applied with EVOv2 as a topper. Anybody go with this combo before and how do you like it. It there any kind of detail spray recommended for this combo. I'll post finished pics when it is done.
Thnaks

[EvolutionDetail]

I got this exact combo on my brand new tacoma, 3 months ago.
Gtechniq coatings is easy to apply, but u seriously have to check each section carefully and repeatedly with buffing removing residue.

Most coatings is just apply on and wipe off. Clean and effortless. However gtechniq is more like a oily residue, that just keeps smearing as you buff, but the oily residue can be buffed off, just takes ALOT of wiping lol.

And that applies to the c1 and exov2

[SlowWRX]

make sure you apply exo within 3-12hrs according to Gtechniq to avoid the chance of the hazing some have had with topping C1 with EXov2

[EvolutionDetail]

Well that's new....
I didn't know about the hazing.
However I waited over 24 hours before applying exov2 on my truck lol

[SlowWRX]

some where having issues. The hazy streaks would show up like a week later

[EvolutionDetail]

Oh... Well I am lucky I didn't have any haze lol.

I applied the c1 with their applicator pad and did it pretty heavy.
Buffed and wiped, thinking it will remove as easy as other coatings, and I was wrong.

I had to polish my entire truck all over again, to do c1 again lol
So I got tired after applying c1 for the 2nd time, so I took a day break before exov2

Ps: honestly if I were to do coating again on my vehicles.
I will just use CqUk or oc2.0 with exov1 on top.
So much easier to work with.
Seriously wipe on and off