3" Lake Country pads

[zm1283]

I am thinking of getting the 3" backing plate and 3" LC pads for tight areas on my vehicles. Will a DA polisher (I have the HF) run this backing plate and pads okay? Are the RPMs too high for a small plate and pads?

[zmcgovern45]

Idk anything about the HF machine, but I use the LC 3" BP and 3" pads on my porter cable all the time and they work perfectly at any speed.

[FUNX650]

I am thinking of getting the 3" backing plate and 3" LC pads for tight areas on my vehicles. Will a DA polisher (I have the HF) run this backing plate and pads okay? Are the RPMs too high for a small plate and pads?

I'm not familiar with an HF DA polisher and won't speculate on it's power/rpms
in regards to running the 3" LC-backing plate equipped with the LC-3" pads.

However...A starting point, for me, would be:
Does your HF DA polisher have a 5/16” thread...in order that it
will accept the LC 3" backing plate...like the PC, GG, & Meg's DA's ?

:)

Bob

[zm1283]

I'm not familiar with an HF DA polisher and won't speculate on it's power/rpms
in regards to running the 3" LC-backing plate equipped with the LC-3" pads.

However...A starting point, for me, would be:
Does your HF DA polisher have a 5/16” thread...in order that it
will accept the LC 3" backing plate...like the PC, GG, & Meg's DA's ?

:)

Bob

Yes as far as I know. I put a CG 5" backing plate on it already and have 5.5" pads for that. I just want the 3" pads for mirror housings, bumpers, etc.

[capnp72]

3" pads and backing plate will work just fine on your DA.

[AutowerxDetailing]

I've got a PCXP and HF DA. All of my LC backing plates will fit on both machines without any issues.

Sent from my LG-VM701 using AG Online

[FUNX650]

Yes as far as I know.
I put a CG 5" backing plate on it already and have 5.5" pads for that.
I just want the 3" pads for mirror housings, bumpers, etc.
Looks like you're good to go then! :props:

:)

Bob