View Full Version : P21s 100% question
lkotsios
04-12-2013, 01:29 PM
Should I let this wax haze before removing or wipe on, wipe off right away?
FUNX650
04-12-2013, 03:45 PM
Should I let this wax haze before removing or wipe on, wipe off right away?
The label on my P21S Concours Wax jar reads:
"apply to one panel and remove".
But it isn't your P21S 100% Carnuba Wax product.
However I would apply/remove both products in this similar manner...
-I would apply the P21S 100% Carnuba Wax to a cool/tepid vehicle surface one panel at a time.
-I would remove it just as it begins to set up,
or allow it to haze over completely. (Follow the:Finger-swipe test<<<M.P.)
-Like most other 100% Carnuba waxes:
I'd bet that it will become somewhat difficult to remove/buff-out
the longer it's allowed to sit after it hazes.
-I'd also bet that if you wait ~12-24 hours...
this P21S 100% Carnuba-Wax can also be "layered" for an unbelievable shine!!
It's cousin always did.
:)
Bob
RTexasF
04-12-2013, 03:57 PM
Just went and looked.....it doesn't say either way but it does say do one section at a time and buff with soft cloth, yada, yada. I've used it both ways with immediate wipe off and let it haze for a very short time. Both methods worked just fine.
ScottB
04-13-2013, 10:01 AM
I have used it each way, and prefer the Pinnacle way. Buff off while slightly damp.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.