Unable to connect PA Foam Gun with Karcher HD 6/15

[Sebs]

Hi all,

I have a Karcher HD 6/15 pressure water system and I recently bought a PA foam lance along with the HD/HDS adapter.

I cannot figure out how to connect them both together... Hope there is someone that has done this before.... Pics below.

http://i1324.photobucket.com/albums/u606/sebratis/Share/IMG-20121222-WA0001.jpg

http://i1324.photobucket.com/albums/u606/sebratis/Share/IMG-20121222-WA0002.jpg

http://i1324.photobucket.com/albums/u606/sebratis/Share/IMG-20121222-WA0003.jpg

http://i1324.photobucket.com/albums/u606/sebratis/Share/IMG-20121222-WA0005.jpg

http://i1324.photobucket.com/albums/u606/sebratis/Share/IMAG0351.jpg

Thanks.

[Mike Phillips]

You need to remove the long steel tube from the handle of your pressure washer wand.

Then replace the steel tube with the Foam Gun.

If that makes sense?


:)

[Sebs]

Thanks Mike.

I'm not sure if that comes off as the whole gun is sealed by screws. I can take off the end nozzle (pic 3) by unscrewing it but the male connector doesn't fit the foam gun adapter.