Fusion Curing Time

[RandyD]

I put Fusion on my car this morning and it rained a little about 2 hours later. Was it cured by then? Thanks

[Mike Phillips]

As a general rule for any wax or synthetic paint sealant, you want a window-of-time to go by from anywhere from a few hours to 12 hours to give all the protection ingredients enough time to fully set-up, dry, polymerize, bond, adhere, stick etc. before doing anything to the surface that will disrupt the protection ingredients.

That said, you're paint is probably okay. Wipe the finish softly with your favorite spray detailer and a clean microfiber towel.

After wiping the paint clean you can always apply another coat just to ensure a uniform appearance with uniform protection.


:)

[margallar]

:iagree:, i would even rewax just for the satisfaction:buffing:

[RandyD]

Thanks guys. I probably will reapply this weekend.

[willtothewong]

The only downside is sometimes I don't have time to wait for the sealant to cure before I top it off with carnuba...

I usually go Klasse AIO + Souveran. Not sure if there are any bonding issues but it does look good to me.

[Jaretr1]

I would definitely rewax because rewaxing with Fuzion is just so pleasurable.

[SON1C]

You're fine, but nothing wrong with throwing another coat on there at your convenience :D

[KBsToy]

You're fine, but nothing wrong with throwing another coat on there at your convenience :D


:iagree: