dinsdetailin
10-09-2012, 11:10 AM
Greetings team of experts!
I recently received my HP60 Spyder. I love this thing, I primarily use it for auto detailing. I also purchased a floor wand to occasionally clean my carpets and as well as the hand tool couches etc....
During the use of my machine, I noticed foam/water shooting out the exhaust port on the output pipe at the bottom of the spyder.
After some research I concluded that I clearly didn't put enough Defoamer into the "dirty" holding tank.... Or did I?
So my question, is there any danger if I were to close off that port during operation? I would say "yes" due to possible overheating?
You guys are the experts, I don't want to be detailing and always wondering if my knees will suddenly be coated in hot foamy liquid.
Any insight into this would be awesome!
I recently received my HP60 Spyder. I love this thing, I primarily use it for auto detailing. I also purchased a floor wand to occasionally clean my carpets and as well as the hand tool couches etc....
During the use of my machine, I noticed foam/water shooting out the exhaust port on the output pipe at the bottom of the spyder.
After some research I concluded that I clearly didn't put enough Defoamer into the "dirty" holding tank.... Or did I?
So my question, is there any danger if I were to close off that port during operation? I would say "yes" due to possible overheating?
You guys are the experts, I don't want to be detailing and always wondering if my knees will suddenly be coated in hot foamy liquid.
Any insight into this would be awesome!