View Full Version : Polish drying out?
david meyers
09-21-2012, 06:36 AM
Using my Porter Cable for the first time with a orange pad & SI polish, I was having a problem with the polish drying out. I was working a small area and applying a good size X to the pad. Polish seemed to dry after a short time. In aiding the removal of the product from the paint I had to mist with detailing spray. Should I be using a more generous application of product; mist with water? Was working in shade & temp. was 75.
Mike Phillips
09-21-2012, 06:48 AM
Prime your pad first and be sure you're not working too large an area at once.
Also, don't buff to a dry buff, you should always have a wet film behind your path of travel.
Hang tight and I'll get the articles that discuss all the above from my article list.
:)
Mike Phillips
09-21-2012, 06:51 AM
First read this, make sure you're not making any of the common mistakes...
DA Polisher Trouble Shooting Guide (http://www.autogeekonline.net/forum/auto-detailing-101/37769-da-polisher-trouble-shooting-guide.html)
Next read this,
How to prime a foam pad when using a DA Polisher (http://www.autogeekonline.net/forum/how-articles/35292-how-prime-foam-pad-when-using-da-polisher.html)
And then this,
Wet Buffing Technique (http://www.autogeekonline.net/forum/tricks-tips-techniques/36237-wet-buffing-technique.html)
:)
ARizzle
09-21-2012, 11:59 AM
Hey Mike, I modified my question that I asked you before...so To prevent dry buffing, should i grab my Kwazar Pro (containing water) and spritz it on the body panel, and apply more product?
Mike Phillips
09-21-2012, 12:49 PM
Hey Mike, I modified my question that I asked you before...so To prevent dry buffing, should i grab my Kwazar Pro (containing water) and spritz it on the body panel, and apply more product?
I do don't so this as a normal practice, that is spritz panels with water. Instead, try to figure out what's causing you to go to a dry buff?
Read through the links I posted above, see if any of them help...
:xyxthumbs:
Glimmer Twin
09-21-2012, 01:06 PM
Mike, I've got a similar/related question. Like the OP I have very limited experience and have used either Swirl X or GG MP3 on an orange pad on a GG ROP. I seem to have a dry pad while running on 4.5 or so but then as the pad slows to a stop when I turn off the machine it leaves a pretty heavy trail/wet spot as it stops. I've been using one of the thicker 4" pads too if that matters. I wasn't sure how to interpret this. Thanks for any input.
Glimmer Twin
09-21-2012, 01:08 PM
Just to clarify the previous comment, there doesn't seem to be a lot product to wipe off when I stop and almost none a lot of the time. That's the main reason I wasn't sure about my technique.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.