ShineMyCar
09-19-2012, 06:18 PM
I did my test application of Klasse Twins tonight.
1) I washed a panel
2) Used Mothers Clay Bar Kit. Clay went smoothely. Being my first clay, the process went easier than I had anticipated. I made sure to use plenty of lubricant during the process. When I got done, the panel was smoothe as glass.
3) Followed instructions of Klasse AIO. With dry panel, I wet the microfiber pad under sink and squeezed it as dry as I could. Was still a little too wet, so I pressed it into a towel, and it was slightly moist. I put a few drops of AIO and rubbed it into panel so I got a slight flash all over. I used WOWO method.
4) After giving panel a little bit of time to dry fully, I used the foam applicator to apply Klasse SG. I wet applicator under sink again, and squeezed it dry. Applied 2 small pea sized dots of SG on the side and folded the foam applicator to spread the product. Then I rubbed it into panel ( was a small quarterpanel ) from all directions. It was getting a little tacky as I was rubbing the product onto panel. At the end of process, there was nothing visible
5) Waited 20 minutes to wipe off expected haze ( but none was visible ). I had my MF towel from kit, and purchased some M34 in case it was tough to wipe off. To my surprise, it wasn't hard to wipe at all. I didn't feel much of anything tacky when I was doing final wiping with MF towel. With all the difficulties I had read of using this product, this was quite surprising to me....... ?
Did I do something wrong, not apply product correctly, or just get a perfect thin coat of SG on and got lucky stumbling on doing it correctly the first application.
This question is for those who have used Klasse products and have some working knowledge with product.
Assuming everything is good tomorrow morning with my test panel, I would like to do the full car tomorrow evening.
Thanks
1) I washed a panel
2) Used Mothers Clay Bar Kit. Clay went smoothely. Being my first clay, the process went easier than I had anticipated. I made sure to use plenty of lubricant during the process. When I got done, the panel was smoothe as glass.
3) Followed instructions of Klasse AIO. With dry panel, I wet the microfiber pad under sink and squeezed it as dry as I could. Was still a little too wet, so I pressed it into a towel, and it was slightly moist. I put a few drops of AIO and rubbed it into panel so I got a slight flash all over. I used WOWO method.
4) After giving panel a little bit of time to dry fully, I used the foam applicator to apply Klasse SG. I wet applicator under sink again, and squeezed it dry. Applied 2 small pea sized dots of SG on the side and folded the foam applicator to spread the product. Then I rubbed it into panel ( was a small quarterpanel ) from all directions. It was getting a little tacky as I was rubbing the product onto panel. At the end of process, there was nothing visible
5) Waited 20 minutes to wipe off expected haze ( but none was visible ). I had my MF towel from kit, and purchased some M34 in case it was tough to wipe off. To my surprise, it wasn't hard to wipe at all. I didn't feel much of anything tacky when I was doing final wiping with MF towel. With all the difficulties I had read of using this product, this was quite surprising to me....... ?
Did I do something wrong, not apply product correctly, or just get a perfect thin coat of SG on and got lucky stumbling on doing it correctly the first application.
This question is for those who have used Klasse products and have some working knowledge with product.
Assuming everything is good tomorrow morning with my test panel, I would like to do the full car tomorrow evening.
Thanks