LC Pads

[kmsdetailing]

I have two DA Buffers. One Meguiars and One Porter. I noticed that one of the vidoes on this site talks about using Kompressor Pads to ensure the pad hugs the vehicle's curves better.

Both DAs have a six inch baking plate. I looked for the 6.5 Kompressor pads but couldn't find it. Would 7" pads be ok on the 6" DA? I will use these pads for polishing, waxing and sealant.

Thanks in advance.

[The Pad Man]

7" pads have 6" loop on them, so you will be fine.

[bmwgalore]

These pads are way too big for a DA.

I wouldn't go bigger than 5.5" on a DA (except The Flex).
Smaller pad are easier to rotate and will work a lot better and faster.

[statusdetailing]

These pads are way too big for a DA.

I wouldn't go bigger than 5.5" on a DA (except The Flex).
Smaller pad are easier to rotate and will work a lot better and faster.


:iagree: I've tried some different combinations but 5.5 lc pads and a 5" backing plate seem to work the best for me. Less vibration and more efficient for sure.

[kmsdetailing]

Thanks eveyone. 5" backing plate with 5.5" pads it is.