What is the paint safe way to remove bugs?

[TechDiver]

What is the best way to remove bugs from the front of the vehicle? In the past I just used a soapy sponge and high pressure sprayer. I want to do things the right way to prevent swirls.

Sent from Android via TapaTalk 2.

[Mazda.Mark]

Take a read:

http://www.autogeekonline.net/forum/how-articles/48718-bug-removal-products-know-how-get-done.html

[cleanmycorolla]

I use UWW+ on fresh ones after a drive!

[Old Tiger]

I use UWW+ on fresh ones after a drive!
I keep a garden sprayer full of UWW+. I pre-soak before every wash be it rinseless or 2 bucket! Bugs come off without issue.

[Mike Phillips]

If the bugs have in fact dried onto the paint, here's what I do...


Tips & Tricks: How to remove dried bug spatter or bug guts (http://www.autogeekonline.net/forum/tricks-tips-techniques/52910-tips-tricks-how-remove-dried-bug-spatter-bug-guts.html)



Bug Spatter can actually eat through and remove paint if left on too long...
http://www.autogeekonline.net/gallery/data/719/BugBGoneTest003.jpg



Tip: Water soften the dried bug guts and splatter with water first.

Trick: Use a towel to hold water in place on a vertical panel.

Here's a tip I posted in 2005, the idea being to use the towel to hold the moisture onto the paint and thus the bug splatter where it can go to work softening and loosening the splatter. A large beach towel works well for this...

This was my Honda Pilot in our garage where I would also wash the garage because it's pretty hard to wash a car in the desert without the dry heat or the wind drying water before you can dry your car.

Take a wash rag and saturate it with water or your car wash solution.

http://archive.meguiarsonline.com/gallery/data/500/2WetWashRag.jpg


Place the wet wash rag on top of the dried bug splatter and allow it to sit for a few minutes. A variation of this would be to use warm/hot water.

http://archive.meguiarsonline.com/gallery/data/500/2WetWashRag2.jpg


To speed up the process, apply some gentle pressure while drinking a cold soft drink and if need be, hum or whistle a little diddy.

http://archive.meguiarsonline.com/gallery/data/500/2WetWashRag3.jpg



A variation of the above but for a larger area would be to use a larger cloth such as a bath towel. Saturate a clean, soft 100% cotton towel with water and place it over the affected area.

http://archive.meguiarsonline.com/gallery/data/500/2WetTowel1.jpg

Another variation for headlights and fenders...
http://archive.meguiarsonline.com/gallery/data/500/2WetTowel2.jpg


Big Picture
The idea being to use some type of bath towel or microfiber towel or even wash cloth or wet chamois to trap and hold water onto the dried bug splatter in order to soften and re-liquefy it so you can more easily remove it without causing damage to the delicate, scratch-sensitive clear coat finish.


:)

[A.P.A.D.]

I love Duragloss products.

Check out this product. Duragloss Bug Remover (BR) #471 (http://www.autogeek.net/duragloss-bug-remover.html) . Let it dwell on the surface and then use Safe Scrub Bug & Tar Pad can be used on glass, chrome, vinyl, fiberglass, paint and clearcoats—100% safe when used with soapy water. (http://www.autogeek.net/pinsafscrub.html) soaked in your wash bucket solution to effortlessly scrub off the bug guts.