PB White Diamond Cure Time?

[BTLew81]

If I'm going to top this with 845, is there a cure time, or can I just hit it with 845 right away?

Thanks.

[Jeff120]

Not that I am aware of, I always apply WD then once Im dont with the vehicle go back and apply my LSP.

[Pockets@PoorboysWorld]

No cure time, buff off and you are good to top with your LSP

[BostonDetails]

I don't know much about glazes but wouldn't the Collinite clean the glaze because of the solvents and what not? I've heard that stuff is pretty powerful.

[BTLew81]

I'm starting to think that as well. Might go with something like PB ex-p instead.

[swanicyouth]

I always top a glaze with products made by the same manufacturer. Like Natty's or EX-P. the only other glaze I've used besides Black Hole was Menzerna Finishing Touch Glaze (old PBMA product) and that I topped with the old FMJ. I think of your topping with something from the SAME manufacturer you should be good, but anyone's else's product as a topper is going to be an experiment , as most sealants need/should be applied to clean (not glazed) paint. I'm thinking mixing and matching a Carnuba and glaze from different manufacturers would likely be fine, as long as its a pure wax, not a cleaner or AIO product.

[Detail-Impressions]

:iagree: same product line till applying waxes

[BostonDetails]

I would think it's dependent on the solvents and cleaners in the LSP.

I put Black Hole on my black TL a few days ago and topped it with Pinnacle Soveren. It looked killer.

[Blackthorn One]

I would think it's dependent on the solvents and cleaners in the LSP.

I put Black Hole on my black TL a few days ago and topped it with Pinnacle Soveren. It looked killer.
I put Fuzion over BH and it looked great.