Question on GG6 - Speed to OPM Conversion

[BTLew81]

Going to be using some Meg's MF pads soon. Cutting says to use 4800 OPM. On the GG6, I am GUESSING this is speed 4. Am I in the ballpark?

[Rsurfer]

That's close enough.:xyxthumbs:
Going to be using some Meg's MF pads soon. Cutting says to use 4800 OPM. On the GG6, I am GUESSING this is speed 4. Am I in the ballpark?

[Capa1970]

Yes speed 4. I used speed 5 recently and destroyed two Optimum cutting pads on one panel. Avoid the higher speeds.

[Belair]

Yes, 3 1/2 - 4 for cutting, 2 1/2 - 3 for finishing. Here's a link with the specifics:

http://www.autogeekonline.net/forum/auto-detailing-101/39948-megs-mf-da-system-problem-5.html#post525964

[g35_coupe]

Yes speed 4. I used speed 5 recently and destroyed two Optimum cutting pads on one panel. Avoid the higher speeds.

I'm sorry; I found that funny and not funny at the same time.

[ski2]

From GG Customer Service:

OPM
1=2500
2=3360
3=4220
4=5080
5=5940
6=6800