BF Wet Diamond sealant VS WG DGPS 3.0

[fenderpicks]

Does anyone know which one of these sealant has a longer durability. im very close to laying my sealant right now and trying to decide which sealant to go with!!

[BobbyG]

1 vote for BlackFire Wet Diamond......

[Audi X2]

1 vote for BlackFire Wet Diamond......

:iagree:

[rider9195]

+3 on the Wet Diamond.

[SRTSean]

I could have sworn somebody just did a side-by-side comparison of these two, including two sections also topped w/Fuzion and Midnight Sun, respectively. I believe the WG products performed better over time with regards to beading/sheeting water.

Here's the link: http://www.autogeekonline.net/forum/product-reviews/47957-review-wolfgang-vs-blackfire.html

[FUNX650]

For what it's worth...I haven't yet had the opportunity of using BFWDS, but I really like WGDGPS 3.0.

BTW...WGDGPS 3.0 is also very, very heat resistant.

http://www.autogeekonline.net/gallery/data/500/Corvettes_Corsa_142.JPG (http://www.autogeekonline.net/gallery/showphoto.php/photo/44974)

:)

Bob

[Chris's FX4]

I really like WGDGPS as well, but haven't used BFWD either.

Even when my truck is dirty, with dust and road spray, the paint still looks clean.

I've got about 7months on my two coats of WGDGPS, and the paint is still beading pretty well.

[TroyScherer]

In my experience so far I have found that they are very similar in durability.


Here is a link to my review.

http://www.autogeekonline.net/forum/product-reviews/47957-review-wolfgang-vs-blackfire.html

[Bigbull2984]

Sorry to bump a old thread, but better than starting a newone.

I got my brother BFTPnS with BFCS.

He is not detail enthusiasts, so I want longest durability possible in Florida. Would he be better off with BFWD or WG3.0?

Of the BF combo I stated above?

[Rsurfer]

For what it's worth...I haven't yet had the opportunity of using BFWDS, but I really like WGDGPS 3.0.

BTW...WGDGPS 3.0 is also very, very heat resistant.

http://www.autogeekonline.net/gallery/data/500/Corvettes_Corsa_142.JPG (http://www.autogeekonline.net/gallery/showphoto.php/photo/44974)

:)

Bob

Very nice, did you have to remove the hood to keep it stabilized while polishing?

[KillaCam]

I just applied a coat of each on each side of my spoiler to test out the durability about two weeks ago.

[matryx]

Isn't BF crystal seal a sealant also? What's the difference between BF CS and BF WD?

[pcw25]

Since we're comparing the two....what happened to the $35 pricetag of BFWD? Because when it came out that was the price (not sale price). Before that it was $30. I hope I'm not the only one who notices these "subtle" changes...

[Bigbull2984]

Since we're comparing the two....what happened to the $35 pricetag of BFWD? Because when it came out that was the price (not sale price). Before that it was $30. I hope I'm not the only one who notices these "subtle" changes...

:iagree:

[mg6045]

Since we're comparing the two....what happened to the $35 pricetag of BFWD? Because when it came out that was the price (not sale price). Before that it was $30. I hope I'm not the only one who notices these "subtle" changes...

yep, i noticed that as well. they need to ditch the (forced) included towel as justifying the price hike in the end probably. It probably cost AG less money to produce the sealant than it used to cost todd. It krept up from 30 to 35... then to 37.50 and now to 40. I stopped buying it just for principle and now use UPP. (pretty much the entire 4star line are the better products at a cheaper price anyway).

People wrote that this was going to happen when AG bought the line and AG insisted it would not.

Fortunately Menzerna is still priced very well and on sale is under 25 dollars and its the most durable sealant of the like out of the 3 of them. (WG and Wet Diamond).