View Full Version : Quick question
Hi there, just a question for you detailers. When polishing a car with the PC, how do you do areas like this?
http://i19.tinypic.com/42n8gfp.jpg
Like under the spoiler, the area with the number plate is, etc.
Thanks.
6LS2
Nuke33
03-12-2007, 06:30 AM
get as close as you can and then by hand or maybe use a edge pad but you can burn the paint if you run it along the edge
justin_murphy
03-12-2007, 06:30 AM
Most PC pads have a rounded edge that allows you to get into these areas. You have to be careful though. The EDGE2000 system is really good at this. It takes time and a delicate hand to learn this though.
You can always come back with and do it by hand it uneasy with the use of a machine.
The only way to get under your spoiler is by hand.
Spot Buffing 4 inch pads (http://www.autogeek.net/4inch-spot-buffs.html)
I use the 4 inch pads to get in some small places.
Thanks guys, I was trying to figure out how I could do the underneath of the spoiler when I did a test spot on the trunk earlier. I took pics if anyones interested
http://i19.tinypic.com/30ktytw.jpg
greg'sgoat
03-12-2007, 12:00 PM
I don't know how it is on your car, but to get under the spoiler on my car (if it was still on) would be to take it off. Ours is 4 easy to get to bolts and it comes right off. Then you can just go right over it with the PC.
Jimmie
03-12-2007, 12:33 PM
PB PwS by hand.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.