View Full Version : New DA Polisher
Critical
11-26-2011, 07:32 PM
Used the "Search function" for advice, but didn't find any topics relating so here's my question.
I've detailed for years using "used polisher's"
I just ordered my first "new" polisher G110v2 from AG of course.
Was just wondering if there is a proper technique to break a new polisher motor in?
I've read to first run it on the slow speed for a few minutes to set the polisher, any other techniques or should that take car of it.
Thanks in advance.
SonOfOC
11-26-2011, 07:54 PM
Not necessary. Use right of the box.
Rsurfer
11-26-2011, 09:31 PM
Set it on speed 6 and go for it.
Used the "Search function" for advice, but didn't find any topics relating so here's my question.
I've detailed for years using "used polisher's"
I just ordered my first "new" polisher G110v2 from AG of course.
Was just wondering if there is a proper technique to break a new polisher motor in?
I've read to first run it on the slow speed for a few minutes to set the polisher, any other techniques or should that take car of it.
Thanks in advance.
Old Tiger
11-26-2011, 09:49 PM
Set it on speed 6 and go for it.
Or get the Megs DA MF and set it to Speed 4!
mark58
11-26-2011, 10:46 PM
As with any motor with brushes you should not run it under load or full speed for few minutes. I would suggest to run it at speed 1 or 2 for few minutes to make sure brushes are seated.
Critical
11-27-2011, 10:33 AM
As with any motor with brushes you should not run it under load or full speed for few minutes. I would suggest to run it at speed 1 or 2 for few minutes to make sure brushes are seated.
This is what I've heard several times, and i will do this just to be sure!
thanks
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.