PDA

View Full Version : menzerna polishes.


jamores23
11-23-2011, 11:54 AM
im looking for some preferences on speeds using a rotary and a DA on
1- sip
2-106fa super finish
3- po85rd.

what speeds and techniques do you guys use?
jamores23
11-23-2011, 09:27 PM
?
Twister
11-23-2011, 10:03 PM
I don have any experience with a rotary but with the DA I suggest speed... Speed is needed for correction. You have to break down the polish and correct the paint.

I use speeds 5&6 for SIP

For 85rd I use 5 but as I finish the section I will slow my speed a little.

Once you get some experience you can adjust your technique to get the results you want. A lot of times I don't pay attention to speed. I look at my results and adjust my technique to get the results I want.
Dr Oldz
11-23-2011, 10:19 PM
Rotary

Sip - 1800
SF 1500-1200
85RD 1200

These are general for me. Pressure is the key. Heavy at first then lessen. It is the key to using these polishes with a rotary IMO.


DA 6 or 5 again changing pressure is very key.
jamores23
11-24-2011, 10:30 AM
yeah i rather use the rotary with menz i seem to get better results with it.
jreblackGT
11-24-2011, 11:28 AM
I got excellant results with 85rd at a notch over 5 with my PCXP.
SonOfOC
11-24-2011, 02:20 PM
A good range is 1200 to 1800rpm for rotary or 4.5 to 5.5 for DA.

If you just want to use one speed then 1500rpm for rotary and 5 for DA will work.

As for arm speed and pressure; it is highly dependant on paint type and defect.




im looking for some preferences on speeds using a rotary and a DA on
1- sip
2-106fa super finish
3- po85rd.

what speeds and techniques do you guys use?