Replacing the wire on my Cyclo and want to polish it up today--It has a ton of wear!

[ShineTimeDetail]

So after 1 year of wondering when my cord on my cyclo would break one of the wires finally pulled lol. This thing is not new and has lots of use on it. I tried once to polish it with a buffing rouge but got no where. Any ideas how to clean this up back to (close to) new condition?

[Dubbin1]

Get the cord replaced then use it to polish it :D

That reminds of a time when I engraved my engraver with another one. One guy I worked with couldn't figure out how in the world I did it :D

[ShineTimeDetail]

Get the cord replaced then use it to polish it :D

That reminds of a time when I engraved my engraver with another one. One guy I worked with couldn't figure out how in the world I did it :D

Maybe ill use my rotary with the 4 inch wool pad?....

[Rav777]

So after 1 year of wondering when my cord on my cyclo would break one of the wires finally pulled lol. This thing is not new and has lots of use on it. I tried once to polish it with a buffing rouge but got no where. Any ideas how to clean this up back to (close to) new condition?

How about Flitz metal Polish to shine it up?