Jsuro
03-20-2011, 09:10 AM
Hi all,
Did the engine bay on a Honda CRV this weekend - my first one with the products mentioned in the title and following instructions on other posts in this forum. Wow!
Don't have a before picture but the car is two years old and the engine had never been done - it was grimy! Sprayed the APC on at 10:1 then agitated with a paint brush. Hosed off, started the car and let it run for a few minutes then finished drying with blown air with my shop-vac in reverse with a small nozzle. Sprayed the 303 on and let it sit for a while then toweled it dry.
Here's the after:
http://www.josesuroeditorial.com/photos/1222043279_GaK2Y-O.jpg
Best,
Jose
Did the engine bay on a Honda CRV this weekend - my first one with the products mentioned in the title and following instructions on other posts in this forum. Wow!
Don't have a before picture but the car is two years old and the engine had never been done - it was grimy! Sprayed the APC on at 10:1 then agitated with a paint brush. Hosed off, started the car and let it run for a few minutes then finished drying with blown air with my shop-vac in reverse with a small nozzle. Sprayed the 303 on and let it sit for a while then toweled it dry.
Here's the after:
http://www.josesuroeditorial.com/photos/1222043279_GaK2Y-O.jpg
Best,
Jose