Foam Cannon Fitting ???

[I Shine]

I recently bought a gas powered 2600 psi pressure washer. It's a Troy Bilt XP series with a Honda motor. I want to buy the Foam Cannon here from Autogeek but none of the pictures of the fitting look like mine. Mine looks similar to an air compressor fitting just with an o-ring and more rounded at the base. Here are some pictures, hopefully someone can point me in the right direction.

Thanks

Spray gun end
http://i169.photobucket.com/albums/u224/jguerra3235/web01.jpg


Nozzle Extension end
http://i169.photobucket.com/albums/u224/jguerra3235/web02.jpg

These two fit togethor
http://i169.photobucket.com/albums/u224/jguerra3235/web03.jpg

[BobbyG]

The photos you posted show the standard screw type connections commonly found on most pressure washers sold. What I think you're looking for is the quick-connect connection like the one below. Shown is a quick type connector.

http://i153.photobucket.com/albums/s225/BobbyG53/Detailing/FoamBlaster01_.jpg (http://www.autogeek.net/mg12001.html)

http://i153.photobucket.com/albums/s225/BobbyG53/Detailing/FoamBlaster05_.jpg

http://i153.photobucket.com/albums/s225/BobbyG53/Detailing/FoamBlaster04_.jpg

What I think you need to do it go to a Lowe's or Home Depot and purchase the standard adapter to go from screw type fitting to a quick-connect fitting.