have a polishing question????

[trhland]

ive been useing my p/c with a white lakecountry foam pad and menzerna 106ff for when i need to polish out flaws light swirls ect. but i have some panels on my truck that this is not strong enough. what should i step up too? i dont want to go crazy agresive. any advise would be great thanks.

[ScottB]

SIP or Wolfgang TSR ...

[trhland]

SIP or Wolfgang TSR ...
withj an orange pad scott?

[trhland]

i was justlooking at the menzerna chart would power finish be better to start with? it says sip is 2 steps ubove 106ff. just wondering. thanks

[ScottB]

106FF and 106FA are both ceramiclear polishes (different abrasives) so in sticking with the line SIP would be next. You can use and orange pad with SIP (or TSR from Wolfgang) and they finish well. You can then move back to 106FF as desired or to 085rd.

PowerFinish is a great one step in my opinion and better on easier to correct paints.

[BobbyG]

Tom,

Take a look at this, it might help you decide..

http://i153.photobucket.com/albums/s225/BobbyG53/Detailing/LiquidSummary31510.jpg


http://i153.photobucket.com/albums/s225/BobbyG53/Detailing/MenzernaProducts-1.jpg

[trhland]

106FF and 106FA are both ceramiclear polishes (different abrasives) so in sticking with the line SIP would be next. You can use and orange pad with SIP (or TSR from Wolfgang) and they finish well. You can then move back to 106FF as desired or to 085rd.

PowerFinish is a great one step in my opinion and better on easier to correct paints.
thank you very much