PDA

View Full Version : wg 3.0 sealant vs. klasse sealant



molarman
05-20-2010, 08:44 AM
which of these would be easier to apply and remove with a da polisher such as the porter cable 7424 xp? i did klasse by hand, and its tough to apply a very thin amount and also to remove afterwards, maybe applied it too thick and didnt wait long enough to remove?

Mike Phillips
05-20-2010, 08:53 AM
Wolfgang Deep Gloss Paint Sealant 3.0 will be easier to remove than Klasse Sealant Glaze in most case.

The Klasse Sealant Glaze MUST be applied "Whisper Thin" or it is very difficult to remove after it dries.

All waxes and paint sealants should be applied using a thin coating but it's easy to lay down a thick coating and if you do that with Klasse SG and it dries it will be hard to remove. Thin is in with all waxes and sealants but especially Klasse SG

There are some instructions for applying this product by hand or machine on the Klasse page here,

Klasse High Gloss Sealant Glaze 33 oz, High Gloss Sealant from Klasse, Klasse SG 33 oz (http://www.autogeek.net/klashiggloss1.html)


http://lib.store.yahoo.net/lib/autogeek/highglossapp1.jpg http://lib.store.yahoo.net/lib/autogeek/highglossapp2.jpg



:)

molarman
05-20-2010, 09:07 AM
thanks mike for the quick reply, think ill try the wg sealant

SATracker
05-20-2010, 09:07 AM
I use Klasse with the PC because I can even things out better as I go along; and yes, Klasse can be brutal to remove. Wolfgang is just...nice!

ScottB
05-20-2010, 09:07 AM
Wolfgang is much easier to apply and remove, and more forgiving to over application. Klasse lasts longer but doesnt look quite as nice. Weaknesses and benefits to all....