Griot's ROP/pads question

[WRAPT C5Z06]

Edit: Was told they're too small. Gotta stick to 6.5" pads.

Can I use 5.5" pads with the new version Griot's ROP(haven't changed the backing plate)?

[Rsurfer]

Edit: Was told they're too small. Gotta stick to 6.5" pads.

Can I use 5.5" pads with the new version Griot's ROP(haven't changed the backing plate)?
You'll need a 5" bp for 5.5" pads. You want at least a 1/4" overhang to prevent from damaging anything that the bp comes in contact with.

[WRAPT C5Z06]

You'll need a 5" bp for 5.5" pads. You want at least a 1/4" overhang to prevent from damaging anything that the bp comes in contact with.
Is there any benefit in correcting ability between a smaller, thinner 5.5" pad vs. a larger, thicker 6.5" pad?

[Rsurfer]

Is there any benefit in correcting ability between a smaller, thinner 5.5" pad vs. a larger, thicker 6.5" pad?
The smaller pads will spin faster and correct faster. If your using the KBM then it may not make a difference.

[WRAPT C5Z06]

The smaller pads will spin faster and correct faster. If your using the KBM then it may not make a difference.
KBM is too advanced for me.

LC doesn't make a 5.5" flat pad??

[WRAPT C5Z06]

Just ordered:

105/205
Three 6.5" LC hydro tech cutting pads
Brinkmann Swirl finder

:buffing: