dennish
03-31-2006, 10:49 AM
I normally don’t like to make comments on new item till I have a chance to use it a few times but the Cyclo is really impressive. I started on one fender using the PC took a couple of times with IP to clean up the finish, I did the other fender with the Cyclo and IP once and it look better then the fender done with the PC. Looking at the Cyclo it looked heavy and clumsy but it is so well balance that it is a breeze to use even on vertical panels. It also has about half the vibration of the PC and seems to glide over the finish without any effort. Also seems to use a lot less down force to get the same results. It looks like I have cut my polishing time in half at least maybe more. The PC it now on the top shelf and the Cyclo has taken it spot – the only time I will need the PC is a couple of tight spots to small for the Cyclo do.
The foam gun is a neat tool also. People that have filters like the CRSpotless will love it since you have to restrict the flow on the filters. The CRSpotless requires less that 2 gallon a minute flow rate the Gilmore Foam Guns flow at 1.5 gallons per minute. You works well with the foam part and OK with rinse but the advantage is you don’t have to use any unfiltered water in the wash.
The foam gun is a neat tool also. People that have filters like the CRSpotless will love it since you have to restrict the flow on the filters. The CRSpotless requires less that 2 gallon a minute flow rate the Gilmore Foam Guns flow at 1.5 gallons per minute. You works well with the foam part and OK with rinse but the advantage is you don’t have to use any unfiltered water in the wash.