Is it safe to squeeze the LC pads after rinsing with water

[alude]

This might be a dumb question but is it safe to squeeze the excees water out of the LC pads? When I mean squeeze, I mean using both hands and turning it or ringing the excess water out and then air dry after. or
should I just let it air dry after rinsing it with clean running water? thanks for your help and advice guys

[Kelso]

i squeeze/ring out as much as possible then put them back on the pc at full speed until nothing else comes out, usually no more than 30 seconds? but try to do this outside

[joe.p]

put the pad between a towel compress the towel to get the excess water out from the pad if the towels wet use another then you can put the pad on the pC to spin out the rest of the water.

[alude]

thanks for the advice guys. Joe.P, so are you saying that it is not good to ring or squeeze the pads with both hands?

[supercharged]

put the pad between a towel compress the towel to get the excess water out from the pad if the towels wet use another then you can put the pad on the pC to spin out the rest of the water.
:iagree: You should be better off this way.

[alude]

thanks guys. I will start doing it the Joe.P way.

[sparkie]

I've always done mine like Kelso! Sounds like the Joe.P way is the way to go!