PDA

View Full Version : Backing Plate Stuck on Makita...



Brandon1
06-07-2009, 06:51 PM
I have a 6" ( I think) AG backing plate. I have had it on my makita for about a month or so now, and when I went to remove it today, I could not get the stinking thing off! I put PB blast in the threads, twisted the hell out of the damn thing, and I cant get the bugger off.

Any tips on removing this backing plate?

michael k
06-07-2009, 07:23 PM
Weird,I just depress the shaft lock and twist.(righty tighty lefty loosey).Backing plate facing you turn counterclock wise.
Does the back plate have a hexagon on the back for a wrench?

SMleczynski
07-02-2017, 10:49 AM
This is an old post but I just ran into a similar issue. I sprayed a little wd-40, then placed the rotary, plate side down, on a microfiber towel then twisted the tool rather than trying to twist the backing plate. Came right off.