help please!

[drastic_detail]

I polished my car today and followed up with UPP. When I removed the sealent the whole car was like streaky and blotchy. Can someone help me get rid of this? Is it maybe I put it on too thick? I wanna top it with fuzion tomorow but need to get rid of these blemishes first! Please help!

[Matt S.]

Sounds like a few things could have happened. This usually occurs when the sealant is a. applied too thick, b. not fully cured, or c. humidity screwed with it. Too thick of an application is most likely, though.

You can either wash the car, or go over it with some QD spray. I'd go with the latter unless it's REALLY bad.

[Matt]

Could it be that the oils left over from the polish caused bonding problems with the sealant?

Did you do a 50:50 wipe down first?

Just my 2c :cheers:

[ASPHALT ROCKET]

Could it be that the oils left over from the polish caused bonding problems with the sealant?

Did you do a 50:50 wipe down first?

Just my 2c :cheers:

This is probably the most likely cause.