electone
11-28-2008, 10:46 PM
Hi, all!
I'm new here and this is my first post.
I purchased wolfgang polymer paint sealant 3.0 approximately two months ago, together with the polish enhancer.
I applied two layers during that time. I was quite impressed as the results exceeded my expectations. I have a Silver Chevrolet Optra (Philippines). The distinction of image was very sharp, it was like mirror.
A week ago, after washing my car, I thought of putting on another layer. I immediately noticed a loss of distinction of image. Instead of a mirror-like image, I now had very fine ripples on the paint, much like the surface of an ocean, but with very fine ripples.
I thought this would be corrected by washing the car all over again, applying the polish enhancer, and applying sealant again. So I ended up adding a fourth layer and having a worse surface than when I started. Very bad ripples as if I could see a thick layer of sealant.
On a very small section of the car, I tried to wash, clay, and rub with the polish enhancer, bit I still have the ripples.
I'm at my wit's end since the car really looks dull now, although surface is slick and very smooth to the touch.
What can I do to effectively remove what's on top of the clear coat and start all over again?
Thank you very muich for your assistance.
I'm new here and this is my first post.
I purchased wolfgang polymer paint sealant 3.0 approximately two months ago, together with the polish enhancer.
I applied two layers during that time. I was quite impressed as the results exceeded my expectations. I have a Silver Chevrolet Optra (Philippines). The distinction of image was very sharp, it was like mirror.
A week ago, after washing my car, I thought of putting on another layer. I immediately noticed a loss of distinction of image. Instead of a mirror-like image, I now had very fine ripples on the paint, much like the surface of an ocean, but with very fine ripples.
I thought this would be corrected by washing the car all over again, applying the polish enhancer, and applying sealant again. So I ended up adding a fourth layer and having a worse surface than when I started. Very bad ripples as if I could see a thick layer of sealant.
On a very small section of the car, I tried to wash, clay, and rub with the polish enhancer, bit I still have the ripples.
I'm at my wit's end since the car really looks dull now, although surface is slick and very smooth to the touch.
What can I do to effectively remove what's on top of the clear coat and start all over again?
Thank you very muich for your assistance.