CLL
07-11-2008, 05:49 PM
I have a blacking plate that came in one of those large kits I purchased from AG. After a few hours of work I could tell the pad was moving around. I had to use more pressure on the PC to get them to stay put. That pressure caused a small nickel size melted spot on the backing plate (I used the washer). If I turn the speed up to 4+ on my PC and only use light pressure it with throw the pad off. The only way to get it to stay on is to use more pressure than I should (burn spot). It does this to all the pads. Is there a heavy duty backing plate out there that's better than the one I have?