View Full Version : I have a 5" backing plate on my DA can I use a 6"foam pad?
Bigwaynester
07-22-2020, 04:14 PM
I have a few sitting around my garage is it ok to use them?
PaulMys
07-22-2020, 04:49 PM
Not sure what machine you have, but technically you could.
But if you have a free-spinning DA, you are asking for a lot of stalling.
FUNX650
07-22-2020, 09:09 PM
Not sure what machine you have,
but technically you could.
But if you have a free-spinning DA,
you are asking for a lot of stalling.
^^^ :iagree:
Bob
Mike@ShineStruck
07-22-2020, 11:23 PM
No because the 6in pad would have a 6.5 face
.
You'd have a 1in overhang on the Velcro side and an 1.5in overhang on the face side
That combo would lead to
Inconsistent cut/finish
Accelerated Pad wear
Get a 5in (5.5 face) pad
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.