Blackfire Pro Ceramic or Mckee's New Ceramic coating

[karwashboy]

Hsas anyone tried these two coatings?

Which one has the easier application? Has a Better look, gloss and slickness? And longer protection?

Sent from my CPH1609 using Tapatalk

[Mike Phillips]

I have not used anything from McKee's since McKee's removed Autogeek as a source for their products. I have used the original McKee's paint coating back when it was in the DP line. That was a long time ago, actually back in 2013. So someone else would have to chime in on the current version.

Here's my write-up from 2013 -


Detailer's Paint Coating

Cleaned & Coated in 3 Hours - 2014 Jeep Grand Cherokee (http://www.autogeekonline.net/forum/ask-expert-featuring-mike-phillips/69413-cleaned-coated-3-hours-2014-jeep-grand-cherokee.html)

http://www.autogeekonline.net/gallery/data/2024/Jeep_Grand_Cherokee_017.jpg








I've used the BLACKFIRE Pro Ceramic Coating a lot and show it in my classes. It's tough as nails. It's so tough - if you miss removing any high spots - you'll have to compound or polish them off.


Here's one of my reviews and how-to's for the BF coating, the article is very in-depth on how to prep the paint and install the coating. Heck it could be a how-to book it has so much information.


Review & How-to: BLACKFIRE Pro Ceramic Coating by Mike Phillips (https://www.autogeekonline.net/forum/2018-product-reviews-by-mike-phillips/119277-review-how-blackfire-pro-ceramic-coating-mike-phillips.html)



BLACKFIRE Pro Ceramic Coating

http://www.autogeekonline.net/gallery/data/3696/BF_Pro_Ceramic_089c.JPG



I'd say any spray-on coating is a tick easier to use than the foam block and microfiber suede patch method.


:)

[Mike Phillips]

This is new and easy,

Review: Wolfgang Uber Ceramic Spray Coating (https://www.autogeekonline.net/forum/product-reviews-by-mike-phillips/125811-review-wolfgang-uber-ceramic-spray-coating.html)


Wolfgang Uber Ceramic Spray Coating

http://www.autogeekonline.net/gallery/data/3978/aUber_Ceramic_Spray_Coating_01.JPG


:)

[karwashboy]

Thank you so much, Mike! I will surely read your write up about BF Pro, I've been eyeing this coating but just checking if someone has compared it to Mckee's. And as far as I know, the new coating from Mk37 uses a dropperand apply it via a foam applicator.

Anyways, appreciated your input.

Sent from my CPH1609 using Tapatalk

[karwashboy]

Hi Mike, how is the new DP paint coating? Is it the same formula from what you used before?

Sent from my CPH1609 using Tapatalk