Natty's white paste wax drying

[james751993]

Hey guys,
I recently used nattys white on my black car after a full detail (wash, ironx, clay, correction, ipa wipedown) let it dry to a "haze" and buffed off with a 600gsm microfibre towel. I noticed it left streaks that were not visible in direct sunlight but were visible with my defect spotting light. The streaks change direction depending on which way I wipe, leading me to believe it's some sort of oil residue.
My question is: does nattys paste wax dry hard or does it remain slightly oily? I noticed it was never quite dry when it hazed... am I wiping off too early??

Thanks guys,
James

[FUNX650]

•There is a wide range between the
application and buffing/residue-removal
processes of Natty:
-You’re not wiping it too early, IMO.

FWIW:
•Whenever I run into these types of situations,
I’ll use a QD spray (usually from the same
Brand as is the Wax—synergy, et al) to further
wipe-down the streaking anomalies.

-In this instance:
Poorboy's World Spray & Gloss is one such QD.


Bob

[Dr Oldz]

Just the opposite.... you are waiting too long to wipe it off.

Apply thin to a panel or two then wipe off.

For your current issue, another wipe down with an ever so slightly dampened microfiber should clear it up.

[james751993]

Thanks guys. Ill give these tips a go. 👍👍