PDA

View Full Version : need help with pf22 hookup


Jim w
04-14-2019, 05:58 PM
Is a M22 1/4 male coupling the right size to
hook up a MTM PF22 to a 2000 PSI electric
Greenworks pressure washer?
Jim w
04-14-2019, 10:24 PM
Bump
rlmccarty2000
04-14-2019, 11:03 PM
Check on the Obsessed Garage website. You can even send them a message and get a quick reply.
vincec
04-15-2019, 02:33 AM
Is a M22 1/4 male coupling the right size to
hook up a MTM PF22 to a 2000 PSI electric
Greenworks pressure washer?

I just purchased the MTM Hydro PF22 Foam Cannon with the spray gun and fittings. It says on Amazon that the Greenworks is the same as my Troy-Bilt and uses the 3/8” Brass M22 at the gun inlet. If you search for the kit it shows photos of all the fittings. The fitting between the short gun and the foam cannon is 1/4", all the others for my setup are 3/8".