View Full Version : Can I go from M205 directly to a sealant?
bcgreen
04-07-2019, 02:27 PM
I have some very light surface marring and want to reapply my sealant, after all its been 5 mos. and I believe its due.
Do I need to do a IPA or can I go from 205 directly to sealant?
glen e
04-07-2019, 02:30 PM
I personally would use IPA after the 205.
Eldorado2k
04-07-2019, 02:33 PM
M205 is my go to polish and I’ve never done an IPA wipedown prior to applying sealant and have never had a problem.
bcgreen
04-07-2019, 02:34 PM
Would that apply to M80 (speed glaze)?
Eldorado2k
04-07-2019, 02:35 PM
Would that apply to M80 (speed glaze)?
I’ve never used M80 but I don’t see why not.
The Guz
04-07-2019, 03:03 PM
Do I need to do a IPA or can I go from 205 directly to sealant?
Not necessary unless you were applying a ceramic coating.
as others have stated you will be fine without an IPA wipedown..
FUNX650
04-07-2019, 08:06 PM
can I go from 205 directly to sealant?
IMO:
You can; you should; and, if you’re
the undaunted type: you will.
Bob
Dr Oldz
04-07-2019, 08:52 PM
IPA and auto detailing should not be used in the same sentence.
When applying a typical wax or sealant, I use a quality DRY MF towel for a final wipe down before application of LSP and never had any issues.
If using a ceramic coating, I use the manufacturers suggested panel wipe.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.