PDA

View Full Version : Solution finish help!


Rrthomas78
02-09-2019, 10:32 AM
I applied solution finish yesterday for the first time to my trim and today there are some spots that are sticky. I assume went to thick. What should I do to smooth this out? My prep was APC followed by a is wipe. I appreciate any help

Sent from my LG-Q710AL using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)
sudsmobile
02-09-2019, 10:58 AM
Did you take it off after you were done? I don't always, but that's the recommendation. I also don't put it on too thick so it's usually not an issue.
Rrthomas78
02-09-2019, 11:08 AM
Did you take it off after you were done? I don't always, but that's the recommendation. I also don't put it on too thick so it's usually not an issue.No I just tried to even it out as best I could and I thought was good. Back story is I was in a use it or lose it situation because I dropped the bottle out of my cabinet and the bottom cracked open. Black dye everywhere.

Sent from my LG-Q710AL using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)
Rsurfer
02-09-2019, 12:56 PM
No I just tried to even it out as best I could and I thought was good. Back story is I was in a use it or lose it situation because I dropped the bottle out of my cabinet and the bottom cracked open. Black dye everywhere.

Sent from my LG-Q710AL using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)

If you don't have more SF to level it out..it will dry in a few days.
Rrthomas78
02-09-2019, 01:02 PM
If you don't have more SF to level it out..it will dry in a few days.I do have more I duct taped the bottle and storing upside down. So another coat is the way to go?

Sent from my LG-Q710AL using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)
Rsurfer
02-09-2019, 01:03 PM
I do have more I duct taped the bottle and storing upside down. So another coat is the way to go?

Sent from my LG-Q710AL using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)

It may be too late, but worth a shot. If not, just let it dry and it will even out somewhat.
Rrthomas78
02-09-2019, 01:06 PM
It may be too late, but worth a shot. If not, just let it dry and it will even out somewhat.Thanks! I tried hitting it lightly with some IPA...didn't do much, I may as well use this bottle up

Sent from my LG-Q710AL using Autogeekonline mobile app (http://r.tapatalk.com/byo?rid=87407)